![]() ![]() > Backup current PHY firmware image Erase flash blocks. Note: The # symbols can continue to print until the image is fully transfered, this can take a few minutes //īytes transferred = 147999664 (8d24bb0 hex) Once it is fully rebooted, it must respond to Enter with a "Username:" prompt.ĭownload image bundle-axel-SS-8_10_130_0.img. Reboot the AP and use the reset command.Program bootloaders? : n //pay attention: the last option must be “n” Full outputs are shown after the final step. ![]() Some output here was removed in order to emphasize the interactive prompts. Note: Do not power cycle the AP during this step. Clear the target TFTP directory, and save the settings.If the TFTP server is on the same subnet as the AP, you can enter the TFTP server's address here. Configure the IP address of the default gateway.Configure the IP address of the TFTP server.Configure the AP with an unused IP address in the TFTP server's subnet.Text manually entered via the terminal is in bold. Verify that the firmware has been loaded with good CRC: OKĬonfigure u-boot to access the TFTP server via IP. See Appendix B for an example that uses MobaXterm to connect to the serial port.Īs soon as the AP starts powering up, enter the ESC key repetitively in the terminal window, until you see the u-boot prompt. The serial port can be configured for 9600 bps, 8 databits, 1 stopbit, no parity, no flow control. Connect a serial cable to the AP's console port (this has a pale blue label that is not labeled "2.5G").See Appendix A for an example of how to set up the Tftpd64 server in Windows. Set up a TFTP server in a network that is cabled to the AP's LAN port (labeled "2.5G"). ![]() Note: These images are only to be used to recover an unbootable AP.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |